Fabrication Bearer Lengths with eVolve Properties
Written By Eric Daniel

A question that sometimes comes up in classes and demos revolves around dimensioning the total bearer length and getting the information on drawing sheets and schedules. The problem originates from the fact that users don’t have the ability to snap to the outside of the bearer. Snapping from the center of the rod on one end and the center on the other end is too limited to help most of the time.

Fortunately, when you use eVolve MEP, you can take advantage of eVolve properties. The eVolve properties give you access to the dimensional information needed to create a tag. The total bearer length is a conglomerate value of the bearer extension (x2) and bearer width. The tag you create will calculate this information for you. To see this process in action, access this instructional YouTube video, Fabrication Bearer Lengths . As you’ll see, the total bearer length is a calculated parameter, not one you’ll find in the properties list.

Besides using normal fabrication reports, an additional benefit of having all the information available inside of Revit is that you can create schedules off the information. This is also demonstrated in the Fabrication Bearer Lengths video.

If you’re not using eVolve MEP yet, fill out the form to request a quick discovery call. Find out how eVolve MEP can give your firm a competitive edge in fabrication and prefabrication.

Don’t forget to share this post!

Related Articles

Best Ways to React to a Downturn

Best Ways to React to a Downturn

The current construction market is showing signs of growth–new housing starts have been increasing steadily for more than a decade and commercial and multi-family construction saw a healthy jump last year. They provide a good opportunity to start developing the skills and resources needed to foresee potential downturns in the market and act proactively to protect your interests.